Recent Posts

Run out of pigs?  Any Updates?

This is the same weekend as cantina on the on.  It's going to be a party.

my grinder died on me fri night while i was just starting to work/cut on the frt of the frame, steering box, etc...  was going to get another grinder but instead i bought replacement parts.  just waiting... again.

i did finish my frt grill center support.

started with this... well 1/2 of nothing

took this when i was on a parts run.  cj3a

finished my 1st attempt over a yr ago but now the length is correct and the hole is in the right place


i did get over to jan's and got some flat plate bent up for my frame boxing.  thanks again jan.



going to put some bitchen access holes and clean up the ends so it looks factory!

oh ya... i need my grinder...  well someday.


 

I have some stickers Dave made.  They suck tho,  made of paper. long gone off of my shit. 

you gonna go? i have all the previous deseert people vids. theyre fuckin awesome and id be down to go

?  who has a big white truck in the east bay with this logo? 

well hey im also from a-stony -a also 

Think it was parked near Emeryville, saw when I was desperately trying to reach IKEA... I was wondering is somebody even visited that, seems there are no roads to this place

a little late but for the south bay people.  dezert people are putting on a premiere for the new dvd at coach's tonight. 7:30.  winchester between campbell ave and budd

 tranny but prob early 80's.  

an early 80s tranny sounds kinda hot, oh and i didnt know you were into trannys at all.    well to make my post alittle more useful, jeeps lookin good!

now that's the fawked up mental thinking this board needs

i'd hit that but they're to old for me now.

 tranny but prob early 80's. 

an early 80s tranny sounds kinda hot, oh and i didnt know you were into trannys at all.    well to make my post alittle more useful, jeeps lookin good!

Good to see an MB grill on the front of that thing.

i agree.

Have you thought about lifting your trans/tcase up a little bit? Sounds like you're only 3/4" away from a flat belly skid...  easier to do now before you have driveshafts built for it and whatnot.

i want to drive it but ur right... now would be the time.  i could move the motor up along with some body pucks.  moving the motor up would help with steering linkage but then the pucks would take away from the original look.  nope... haven't even thought about it.  

What's the plan for clutch linkage?  Hydraulic? Chain?

hydraulic.  i have a clutch reservoir and slave cylinder from a jeep tranny i picked up free... well it was a "do u want that too".  no idea what tranny but prob early 80's.  i'll use this setup as a guide to give me ideas.  if i'm lucky maybe it will work.